|
DOWNLOADS:
A higher viscosity chemical form release ideally suited for hotter weather and more porous substrates. Hangs well on aluminum or steel in hot weather. Chemical releasing properties allow very thin applications. When applied according to our directions, will not stain concrete or cause bondability problems. Contains no silicones or waxes.
Compliances
Corps of Engineers CEGS-03300, Section 10.8 Form Coating.
Navy Dock and Piers 56359
V.O.C. Compliant |
Features
Prevents buildup on forms
Nonstaining, reduces cleanup time s
Will not evaporate
Excellent in hot weather or on more porous forms
Surfaces left bondable
Contains no silicones, waxes or paraffins l
Extends form life
|
Usage
Chemically releases concrete from steel, plastic, plywood and composition forms
Prevents buildup of hardened concrete on ready-mix trucks, pipe plants, vibratory screeds, small batch mixers, shoring and scaffolding equipment, power trowels or forming hardware
Prolongs life of forms and formliners
Physical Properties
Bulk Density: 7.7 lbs./gal
ASTM D88 Viscosity: 45 SUS @ 100°F
ASTM D97 Pour Point: -20°F
ASTM D92 Flash Point: 165°F
ASTM D1500 Color: 2+
Coverage
Steel, Aluminum: 2,000-2,500 sq. ft./gal.
BB Grade Plywood: 500 sq. ft./gal.
Rough Sawn Lumber:
First Use: Two coats @ 500 sq. ft./gal.
Subsequent Uses: 1,000 sq. ft./gal.
High Density Plywood: 1,000-1,500 sq. ft./gal.
Med Density Plywood: 1,000-1,250 sq. ft./gal.
Packaging
5 gal./18.9 L pails
55 gal./208 L drums
275 gal./1,045 L totes
*Available in winter blend for ease of spraying in cold weather applications |
Application
SURFACE PREPARATION
Forms should be dry and clean prior to application. When architectural or exposed concrete surfaces are involved, be sure to remove all buildup or existing form oil, and replace any damaged panels prior to application.
METHOD
Spray apply with flat spray tip to provide the greatest economy. Apply in very thin film due to the concentration and chemical method of operation.
STORAGE TO KEEP MOISTURE OUT
Store inverted or on side, away from excessive heat. Retighten bungs immediately after each use to avoid contamination.
Cleanup
Sprayers and other application equipment can be cleaned with UNITEX CITRI-CLEAN.
Cautions
Contains petroleum solvents
Do not use near open flame
Use only with adequate ventilation
Red label NOT required
Do not cut top off drum with torch
Do not dilute or alter
For industrial use only |