|
Description
A technologically advanced, semi-rigid, solvent-free, moisture-insensitive, non-sag vertical epoxy joint filler and sealer.
Ideally suited for filling control joints in security settings.
|
|
Usage
- Filling vertical non-moving saw cut control joints and random cracks
- As a flexible, low modulus adhesive
Appearance
Component A - Gray
Component B - White
Shelf Life: 1 yr. in original unopened container
Gel Time (60 g mass): 30 min. at 73°F ?° (23°C)
Storage Conditions: Store at 40-90°F (5-32°C); condition material to 65-85°F/18-29°C before using
Consistency: Pourable, self-leveling liquid
Coverage
22 oz./600 ml cartridge yields 37 cu. in./600 cu. cm
1 gal./3.8 L of mixed epoxy yields 231 cu. in./3,746 cu cm
Packaging
22 oz./600 ml cartridges
1 gal./3.8 L units (two .5 gal cans)
2 gal./7.6 L units (two 1 gal. cans)
10 gal./37.9 L units (two 5 gal. pails)
110 gal./416.4 L units (two 55 gal. drums)
|
|
Application
SURFACE PREPARATION: Surface must be clean and sound. It may be dry or damp, but free of standing water. Remove surface contaminants i.e. dust, grease, curing compounds, impregnations, waxes, foreign particles and disintegrated materials.
Concrete: Sandblast or use other approved mechanical means.
Steel: Sandblast to white metal finish.
MIXING: Pre-mix each component thoroughly. Place 1 part by volume of component A and 1 part by volume of component B into a clean pail. Mix thoroughly for 3 min. with low-speed drill (400-600 rpm) until uniformly blended. Mix only the quantity that can be used within its gel time.
TO APPLY: Place PRO-FLEX GEL in joints or cracks or use low pressure application equipment.
|
|
Limitations
- Minimum substrate temperature is 40°F (5°C).
- For best results, use between 65° and 85°F (18-29°C).
- Do not thin. Solvents will prevent proper cure.
- Material is a vapor barrier after cure.
- Minimum age of concrete should be 28 days.
- Not for sealing cracks under hydrostatic pressure.
- Not to be used in moving cracks or expansion joints.
|
|
Cleanup
EQUIPMENT: Uncured material can be removed with Unitex CITRI-CLEAN or other approved solvent. Cured material can only be removed mechanically.
MATERIAL: Collect with absorbent material. Flush area with water. Dispose of in accordance with local, state and federal disposal regulations.
|
|
First Aid
EYE CONTACT: Flush immediately with plenty of water for at least 15 minutes. Contact physician immediately.
RESPIRATORY CONTACT: Remove person to fresh air.
SKIN CONTACT: Remove any contaminated clothing. Remove epoxy immediately with a dry cloth or paper towel. Solvents should not be used as they carry the irritant into the skin. Wash skin thoroughly with soap and water.
CURED EPOXY RESINS ARE INNOCUOUS.
|
|
Cautions
- Component A - Irritant (prolonged contact with skin may cause severe burns; avoid eye contact.)
- Component B - Corrosive (contact with skin may cause severe burns; avoid eye contact.)
- Product is a strong sensitizer. Use of safety goggles and chemical resistant gloves are recommended.
- Use of a NIOSH/MSHA organic vapor respirator is recommended if ventilation is inadequate.
- Avoid breathing vapors. Use adequate ventilation.
|
