|
Description
An economical, easy-to-use method for producing beautiful exposed aggregate
concrete flatwork with consistent results. Available in two strengths: regular (blue)
and deep (red). It temporarily halts the set of portland cement at the surface while
concrete below the surface cures normally.
The surface concrete can then be washed or brushed away, exposing the aggregate.
|
|
Usage
- Exposes aggregate on floor slabs, sidewalks, tilt-up and precast panels or any
normal horizontal concrete
- Produces roughened bonding surfaces for subsequent concrete toppings
- Roughens horizontal surfaces for construction joints in power plants, dams and
other civil engineering projects.
Coverage
100-150 sq. ft./gal.
Packaging
1 gal./3.8 L units (six per case)
5 gal./18.9 L pails
55 gal./208 L drums
Cleanup
Equipment can be cleaned with water.
|
|
Application
SURFACE PREPARATION: Place and level concrete. Do not overwork when closing off
the surface or the aggregate will be driven down, reducing the depth of exposure.
Step 1 – As soon as the bleed water has disappeared (usually 30 minutes
or less), uniformly apply TOP ETCH with a pump-up garden type sprayer on top of the
concrete, avoiding puddles and overspray.
Step 2 – Cover the concrete with black plastic sheeting, securing the
edges to prevent ballooning. Retarded concrete will eventually harden, so the surface
should be periodically checked. Under normal conditions TOP ETCH will retard the
surface for 18 hours. With a temperature of 85°F and above, you may need to wash the
same day.
Step 3 – Check a small area to be sure the subsurface concrete has
cured sufficiently (usually overnight). One section at a time, remove plastic sheeting
and pressure wash surface to expose aggregates. On hot, windy days, after uncovering a
section, mist entire area with water to prevent flash setting. Then start washing to
expose aggregates.
Step 4 – To highlight the natural color of aggregate, seal with BRIGHT
ROCK SEALER.
|
|
Limitations
- Not for vertical concrete or form application.
- Do not use on concrete containing calcium chloride or other set accelerators.
- Protect from freezing.
|
Cautions
- Remove retarded concrete no later than 18 hrs. after TOP ETCH is sprayed on concrete.
- Variations depend on temperature, psi of concrete and water-to-cement ratio. If
the temperature exceeds 85°F, wash the same day.
- Test panels at your plant or jobsite should always be preformed.
- Should not be stored in metal sprayers for extended periods.
|
